Hw 130 Motor Control Shield For Arduino Datasheet Jun 2026

While HW‑130 is a generic clone, its electrical behaviour is identical to the Adafruit Motor Shield V1 and the L293D datasheet. For pin‑level details, refer to the Texas Instruments L293D datasheet . The shift register (74HC595) datasheet is also widely available. The combination of these two ICs defines the shield’s capabilities.

Allows for multiple shields to be stacked, enabling up to 8+ motors.

Up to with 8-bit speed selection. Up to 2 stepper motors (unipolar or bipolar). hw 130 motor control shield for arduino datasheet

AF_Stepper stepper1(48, 1); // 48 steps per revolution, motor port #1 (M1+M2)

This comprehensive guide serves as an extended technical datasheet, detailing the shield's hardware architecture, pin configurations, power management, and software implementation. Technical Specifications While HW‑130 is a generic clone, its electrical

3-pin male headers located at the corner of the board. They supply 5V, Ground, and Signal (Pins 9 and 10) directly to standard RC servo motors. Arduino Programming and Libraries

Used for PWM speed control.

3-pin header mapped directly to Arduino Digital Pin 10.

All are functionally identical to HW-130. The combination of these two ICs defines the

Up to 2 stepper motors (unipolar or bipolar, single coil, dual coil, or interleaved) Up to 2 hobby servo motors (5V)