This allows the capacitors in the power supply to discharge completely.
: Inspect the cable for any visible kinks or damage. If possible, swap it with a known-good pendant or cable to rule out a faulty connection. fanuc starting system software please wait
If you have cleared the SRAM, verified the modules are seated, and the control still hangs on the "Starting System Software" screen, a physical component has likely failed. This allows the capacitors in the power supply
If you're encountering the "FANUC Starting System Software Please Wait" message on your FANUC control system, it typically indicates that the system is initializing or attempting to load the necessary software components. This message can appear during the startup process of FANUC CNC systems or other machines equipped with FANUC controls. Here are some insights and steps you can take to troubleshoot or understand the situation better: If you have cleared the SRAM, verified the
on the 7-segment display on the main board while it's stuck?
The controller has run out of memory, often seen when using vision systems. Step-by-Step Troubleshooting Guide 1. Initial Checks
FANUC controls use a "From/SRAM" module or a PCMCIA Flash Memory card (depending on the generation) to store the system software.