Evoko Liso Factory Reset Verified -

The device will format its internal storage, clear all data, and flash the firmware from the USB drive.

the device. It should automatically boot from the USB.

If you still have access to the Admin PIN, this is the cleanest way to wipe the device. Tap the "Admin" button on the Liso screen. evoko liso factory reset verified

The latest Evoko Liso firmware image file (downloaded from the official Evoko support portal). Step-by-Step Instructions

Unplug the Power over Ethernet (PoE) cable or the power adapter from the back of the Evoko Liso unit. The device will format its internal storage, clear

Uses a pinhole button behind the cable routing clip.

Download the from the official Biamp/Evoko Downloads . If you still have access to the Admin

Ensure the paperclip is inserting fully and you are holding it long enough.

: Do not remove the USB or power until the screen explicitly displays the text: "Flash has been successfully completed!" Reconfiguration

: If you are actually using the newer Evoko Kleeo , the reset is physical—remove the back casing and use a paperclip to press the tiny reset hole while the device is powered.

Performing a factory reset on an Evoko Liso is a straightforward process when you follow the verified USB method. By carefully preparing your tools and following each step, you can resolve persistent software issues, clear out old configurations, and get your meeting room system back on track. If you encounter difficulties at any stage, refer to the troubleshooting section or contact Biamp Technical Support for further assistance.