Dtape Dt50 User Manual Pdf Jun 2026

Use this mode to measure the height of a wall or structure when direct access is blocked.

Press once to turn the device on. Press again to activate the laser beam, and press a third time to capture a single distance measurement. dtape dt50 user manual pdf

The D-Tape DT50 utilizes a Class 2 laser. While safe for accidental exposure, the following precautions must be observed: Use this mode to measure the height of

The default measurement reference is the rear edge of the device. Short-press the reference key to switch to the front edge . The D-Tape DT50 utilizes a Class 2 laser

The target is either too close (less than 0.05m) or too far (over 50m). Received signal too weak

Since I cannot provide a direct download link, use these verified methods:

Switchable between Meters (M), Inches (In), and Feet (Ft). Core Measurement Modes