Cwfl-6000 Manual Jun 2026

The display will flash the target temperature for the low-temperature circuit (laser).

Up to 14kW (depending on environmental conditions and water temperature). Dual Cooling Circuit:

Note: This article is for informational purposes. Always refer to the physical manual provided by the manufacturer (e.g., S&A Teyu) for specific wiring diagrams and warranty terms.

Wait at least 3 minutes after cutting power before performing maintenance to avoid high-voltage shock. cwfl-6000 manual

Are you configuring the chiller for a (e.g., IPG, Raycus, Maxphotonics)?

Use purified water, distilled water, or deionised (DI) water . Never use tap water, as mineral buildup will clog the laser's internal cooling channels.

: Detailed warnings regarding high-voltage electrical safety, proper grounding, and the importance of never running the chiller without water to prevent pump damage. The display will flash the target temperature for

If operating in temperatures below 0°C, you must add a laser-safe antifreeze (like ethylene glycol). Warning: Always drain and flush the system once the weather warms up, as antifreeze can be corrosive over long periods. 5. Troubleshooting Common Alarms

Immediately inspect all pipes for water leaks after the first startup. ⚠️ Essential Safety & Maintenance

Open the drain valve at the bottom of the chiller and empty the tank completely. Flush the tank with fresh distilled water once. Always refer to the physical manual provided by

There are two ways to adjust temperature parameters:

: Simultaneously cools the fiber laser and the optics/laser head via separate high and low-temperature systems, which prevents condensation and saves space. Cooling Capacity : Approximately Communication : Supports Modbus-485