(Only in Repeater Mode) The WTR2 has a "Disconnect Threshold" setting (usually -70dBm to -90dBm). If the main router’s signal drops below this level, the WTR2 will stop trying to connect.
He pressed it.
“In the event of automated failure, the user may manually adjust the frequency offset. Rotate the encoder to adjust the carrier wave. The goal is to achieve a SINAD (Signal-to-Noise and Distortion) ratio of greater than 12dB.”
The Delay function sets a waiting period before the first shot is taken. This is useful when you need to get into position before the camera starts firing. aodelan wtr2 user manual
The Ultimate Guide to the Aodelan WTR2: A Comprehensive User Manual
“ Calibration Failure. Solution: Check antenna connectivity. Reset unit via the recessed reset button (Item D) located under the battery flap.”
Failure to follow safety guidelines can result in equipment damage, injury, or death. The Aodelan WTR2 is often used to control heavy machinery. (Only in Repeater Mode) The WTR2 has a
| Parameter | Value | |-----------|-------| | Model Name | Aodelan WTR2 | | Frequency | 433.05 – 434.79 MHz | | Modulation | ASK / OOK | | Output Power | <10 mW (EIRP) | | Operating Distance | Up to 100m (open field) | | Transmitter Voltage | 2.4 – 3.2V DC (2x AAA) | | Receiver Voltage | 12V DC ±10% or 24V DC ±10% | | Standby Current | <5 mA (receiver) | | Relay Contact Rating | 5A @ 30V DC / 250V AC (resistive) | | Working Temperature | -20°C to +70°C | | Certification | CE, FCC (varies by batch) |
Yes, the WTR2 uses standard AAA batteries, which are user‑replaceable. However, if you have a different AODELAN model (such as the Pebble or certain Bluetooth remotes), the battery may be built‑in and not replaceable. For the WTR2 specifically, AAA batteries are fully replaceable.
Check if the receiver is turned on and the light glows red when you press the button. If it glows red but the camera doesn't fire, the cable is likely loose. LCD is faint: Replace the AAA batteries in the transmitter. “In the event of automated failure, the user
He flipped to the troubleshooting section in the back, the last resort of every technician.
Half-press to focus (AF), full-press to take a picture (or begin BULB exposure). Directional Pad/Buttons: Used to navigate menu settings.
